Water Pump: Service and Repair

REMOVAL

WATER PUMP
1. Drain the engine coolant.

WARNING:
System is under high pressure when the engine is hot. To avoid danger of releasing scalding engine coolant, remove the cap only when the engine is cool.

2. Remove drive belts.
3. Remove the timing belt.
4. Remove the timing belt idler.
5. Remove the power steering pump and the power steering pump bracket .
6. Remove the water pump.
(1) Remove the 4 bolts and pump pulley.
(2) Remove the 2 bolts(C), then remove the alternator brace (A).
(3) Remove the water pump (B) and gasket.





INSTALLATION

WATER PUMP
1. Install the water pump.
(1) Install the water pump (B) and a new gasket with the 3 bolts(C).

Tightening torque
11.8 - 14.7Nm (1.2 - 1.5kgf.m, 8.7 - 10.8lb-ft)





(2) Install the alternator brace with the 2 bolts.

Tightening torque
19.6 - 26.5Nm (2.0 - 2.7kgf.m, 14.5 - 19.5lb-ft)


(3) Install the 4 bolts and pump pulley.
2. Install the power steering pump and the power steering bracket.
3. Install the timing belt idler.
4. Install the timing belt.
5. Install drive belts.
6. Fill with engine coolant.
7. Start engine and check for leaks.
8. Recheck engine coolant level.