Component Inspection

Component Inspection

1. Ignition "ON" & Engine "OFF" and Using a scan tool, clear the DTC.
2. Ignition "OFF".
3. Disconnect the battery (-) terminal cable from the battery, and wait at least one minute.
4. Disconnect Passenger OC_STPS connector.
5. Substitute the OC Passenger Sensor Mat and check for proper operation.
6. Is DTC present problem?
YES
1) Substitute a known-good SRSCM, and check for proper operation.
If the problem is corrected, replace SRSCM and then go to "Verification of Vehicle Repair" procedure.
2) Substitute the SRS main harness and check for proper operation.
If the problem is corrected, replace SRS main harness and then go to "Verification of Vehicle Repair" procedure.
NO
1) Substitute a known-good OC Passenger Sensor Mat, and check for proper operation.
If the problem is corrected, replace OC Passenger Sensor Mat and then go to "Verification of Vehicle Repair" procedure.