Component Inspection

Component Inspection

[Check wheel / tire]
1. Cool the heat of the Sensor 1's wheel / tire.
2. IG OFF & IG ON. And Wait 1 minute.
3. Monitor the parameter of 'S1 TEMP.' on the 'TPMS exciter'. or scantool.
A. Specification : 'S1 TEMP.' is Less than 248°F (120°C)
4. Is parameter within specifications?
YES
1) Fault can be because of temporary overheating.
2) Go to "Verification of vehicle Repair" procedure.
NO
1) Replace Sensor 1 and register sensor ID with 'TPMS exciter'.
2) Go to "Verification of Vehicle Repair" procedure.