Component Inspection

Component Inspection

[Check wheel/tire]
1. Cool the heat of the Sensor 4's wheel/tire.
2. IG OFF & IG ON. And Wait 1 minute.
3. Monitor the parameter of 'S4 TEMP.' on the 'TPMS exciter'. or scantool.
A. Specification : 'S4 TEMP.' is Less than 248 °F (120 °C)
4. Is parameter within specifications?
YES
1) Fault can be because of temporary overheating.
2) Go to "Verification of vehicle Repair" procedure.
NO
1) Replace Sensor 4 and register sensor ID with 'TPMS exciter'.
2) Go to "Verification of Vehicle Repair" procedure.