Repair procedures

Removal

1. Drain the engine coolant.
2. Remove the drive belt (A).




3. Remove the exhaust manifold heat protector (A).




4. Remove the water inlet pipe nut.
5. Remove the water pump (A) and gasket.






Installation

1. Install the water pump (A) with a new gasket.

Tightening torque :
18.6 - 23.5N.m (1.9 - 2.4kgf.m, 13.7 - 17.4lb-ft)





2. Install the water inlet pipe nut.

Tightening torque :
18.6 - 23.5N.m (1.9 - 2.4kgf.m, 13.7 - 17.4lb-ft)


3. Install the exhaust manifold heat protector (A).

Tightening torque :
7.8 - 11.8N.m (0.8 - 1.2kgf.m, 5.8 - 8.7lb-ft)





4. Install the drive belt (A).




5. Fill the engine coolant.
6. Start the engine and check for leaks.
7. Recheck the coolant level.