W/Harness Inspection

Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.
3. Has a problem been found?






Power Circuit Inspection

Check Power To Range Switch,
1. Disconnect "TRANSAXLE RANGE SWITCH" connector.
2. Ignition "ON" & Engine "OFF".
3. Measure voltage between power terminal of the transaxle range harness connector and chassis ground.

Specification : Approx. B+









4. Is voltage within specifications?






Signal Circuit Inspection

1. Ignition "OFF" ".
2. Disconnect "TRANSAXLE RANGE SWITCH" and "TCM (PCM)" connector.
3. Measure resistance between each terminal of the sensor harness connector and TCM (PCM)harness connector as below.
Specification :













4. Is resistance within specifications?