Component Inspection

Component Inspection

Check Solenoid Valve
1. Ignition "OFF".
2. Disconnect "A/T SOLENOID VALVE" connector
3. Measure resistance between "PCSV-D (DCCSV)" terminal and "Ground" terminal of the ATM SOLENOID VALVE harness connector.

Specification : Approximately 2.7-3.4 Ohms (20 °C)









4. Is resistance within specifications?





Check PCM/TCM
1. Connect scantool to data link connector (DLC)
2. Ignition "ON" & Engine "OFF".
3. Select A/T Solenoid valve Actuator test and Operate Actuator test.
4. Is Actuator Testing performed normally?









ACTUATOR TEST CONDITION
1. IG SWITCH ON
2. TRANSAXLE RANGE SWITCH is normal
3. P RANGE
4. Vehicle Speed 0 km/h
5. Throttle position sensor <1V
6. IDLE SWITCH ON
7. ENGINE RPM 0