Scantool Diagnostics

Monitor DTC Status

1. Clear the DTC with GDS.
2. Operate the vehicle within the following conditions:
- Engine run time at idle over 10 minutes
- Engine Oil Temp. is between 20 °C (68 °F) and 110 °C (230 °F)
3. Ignition"ON" & Engine"OFF"
4. Using a GDS, monitor DTC
5. Go to applicable troubleshooting procedure for the following conditions
- If any DTCs related to OCV (P0011) are stored, do ALL REPAIRS associated with those codes before proceeding with this troubleshooting procedure.
- If DTC P0340 is set again, go to next step as below
- If other DTCs are stored, go to the applicable troubleshooting procedure.
- If no DTC output, go to "Verification of Vehicle Repair" procedure.
6. Click "DTC Status" on the menu bar to see DTC's information.
7. Confirm that "DTC Readiness Flag" indicates "Complete". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions
8. Read "DTC Status" parameter




9. Is parameter displayed "History (Not Present) fault"?

NOTE:
- History (Not Present) fault : DTC occurred but has been cleared.
- Present fault : DTC is occurring at present time.