Component Inspection

Component Inspection

1. Check status
(1) IGN "ON" & Engine "OFF"
(2) Connect scantool to Data Link Connector (DLC)
(3) Erase the DTC and Monitor the "ECU STATUS' Parameter on the Scantool.
A. Specification : 'LEARNT'




Fig 1) The current data in normal state
(4) Is "ECU STATUS' Parameter "Locked"?
YES
- Keep "KEY ON" status for 1 hours to withdraw "Locked by Timer" status. Then register transponder and go to "Verification of Vehicle Repair" procedure.
NO
- Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.