Component Inspection

Component Inspection

1. Check auto cruise switch
(1) IG "OFF" and disconnect Cruise remocon connector.
(2) Measure resistance between terminals 7 and 8 of Cruise remocon connector with "ON" switch depressed. (Component side)
A. Specification :









(3) Is the measured resistance within specification?
YES
- Substitute with a known - good PCM and check for proper operation.
If the problem is corrected, replace PCM and go to "Verification of Vehicle Repair" procedure.
NO
- Substitute with a known - good auto cruise switch and check for proper operation.
If the problem is corrected, replace auto cruise switch and go to "Verification of Vehicle Repair" procedure.

CAUTION:
There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function to reuse the PCM on the others.