Monitor Scantool data

Monitor Scantool Data

1. Connect scantool to Data Link Connector (DLC)
2. Ignition "ON" & Engine "ON".
3. Maintain the vehicle standing still.
4. Monitor the "Lateral Acceleration Sensor, Yaw Rate Sensor" parameter on the Scantool.
A. Specification : Approx. Lateral Acceleration Sensor : -0.01G
Approx. Yaw Rate Sensor : -1 deg/s




5. Is parameter displayed within specifications?
YES
1) Fault is intermittent caused by faulty sensor cluster and/or faulty HECU or was repaired and HECU memory was not cleared. Go to "Verification of Vehicle Repair" procedure.
NO
1) Go to "Component Inspection" procedure.