Verification of Vehicle Repair

Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.
1. Connect scan tool and select "Diagnostic Trouble Codes (DTCs)" mode
2. Using a Scantool, Clear DTC.
3. Operate the vehicle within DTC Detecting Condition in General Information. (Start and drive vehicle in gear and maintain vehicle speed is Approx. 20 Km/h or more (12 mph or more))
4. Are any DTCs present ?
YES
1) Go to the applicable troubleshooting procedure.
NO
1) System performing to specification at this time.