Power Door Lock Actuator: Testing and Inspection

POWER DOOR LOCK ACTUATORS

INSPECTION

FRONT DOOR LOCK ACTUATOR
1. Remove the front door trim.
2. Remove the front door module.




3. Disconnect the connectors (6 P) from the actuator.




4. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

REAR DOOR LOCK ACTUATOR
1. Remove the rear door trim panel.
2. Remove the rear door module.




3. Disconnect the connectors (6 P) from the actuator.




4. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

TAIL GATE LOCK ACTUATOR
1. Remove the trunk trim.




2. Disconnect the 4P connector from the actuator.




3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

FRONT DOOR LOCK SWITCH
1. Remove the front door trim.
2. Remove the front door module.




3. Disconnect the connectors (6P) from the actuator.




4. Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.

REAR DOOR LOCK SWITCH
1. Remove the rear door trim panel.
2. Remove the rear door module.




3. Disconnect the connectors (6P) from the actuator.




4. Check for continuity between the terminals in each switch position according to the table.

TAIL GATE LOCK SWITCH
1. Remove the tail gate trim.




2. Disconnect the 6P connector from the actuator.




3. Check for continuity between the terminals in each switch position according to the table.