Parking Brake System: Adjustments

PARKING BRAKE SHOE CLEARANCE ADJUSTMENT

DISC BRAKE TYPE
1. Raise the vehicle, and make sure it is securely supported.
2. Remove the rear tire and wheel.
3. Remove the plug from the disc.
4. Rotate the toothed wheel of adjuster by a screw driver until the disc is not moving, and then return it by 5 notches in the opposite direction.





PARKING BRAKE PEDAL STROKE ADJUSTMENT
1. Push the parking brake pedal to its maximum point of travel.

Release and repeat 2 additional times.

Adjust the nut (B) so that the parking brake pedal stroke is 88 - 98mm(3.46 - 3.86in) at an operating effort of 196N(20kgf, 441b).





NOTE
1. The parking brake adjustment must be carried out after adjusting the rear shoe.
2. After adjusting parking brake, verify the following
a) Must be free from interference between adjusting nut and pin.
b) Verify that the brake is not dragging.