Terminal and Connector Inspection

TERMINAL & CONNECTOR INSPECTION
Be sure to perform "TERMINAL & CONNECTOR INSPECTION" before doing "INSPECTION PROCEDURE" for troubleshooting of each DTC.
1. Visually inspect all connectors related to the affected circuit for damage and secure connection.
2. Inspect terminals for damage and corrosion.

CAUTION:
Avoid damaging connectors during the inspection process.

3. Are any problems found?
NO
> Go to next step (INSPECTION PROCEDURE).
YES
> After repairing the trouble part, check whether DTC occurs or not.

PREPARATION OF INSPECTION
1. Turn the ignition switch to LOCK.
2. Disconnect the battery negative cable from the battery and wait for at least 3 minutes.
3. Remove the DAB module and disconnect the DAB connector.
4. Disconnect the connectors of the PAB, SAB, CAB, BPT, FIS and SIS.
5. Disconnect the SRSCM connector.