Repair Procedures

REMOVAL

1. Turn the ignition switch OFF.
2. Pull up the lock(A) of the ABS control unit 25P connector , then disconnect the connector.




3. Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.




4. Loosen the 3 ABS HECU bracket bolts (A) and 1 nut(B) , then remove HECU and bracket.





CAUTION:
1) Never attempt to disassemble the HECU.
2) The HECU must be transported and stored in.
3) Never shock to the HECU.

5. Remove the 3 damper screws and washer , then remove the bracket.

INSTALLATION

1. Installation is the reverse of removal.
2. Tighten the HECU mounting bolts and brake tube nuts to the specified torque.

Tightening torque: HECU damper screw : 10.98 - 14.02 Nm (1.12 - 1.43 kgf.m, 8.1 - 10.34 lb-ft) / HECU bracket mounting bolt, nut : 7.85 - 9.8 Nm (0.8 - 1.0 kgf.m, 5.79 - 7.23 lb-ft)