Even After the Engine Is Started, the ABS Warning Lamp Remains on

DETECTING CONDITION






INSPECTION PROCEDURES
CHECK DTC OUTPUT.
1. Connect the Hi-Scan (pro) to the 16P data link connector located behind the driver's side kick panel.
2. Check the DTC output using Hi-Scan (pro).
Is DTC output?
NO
> Repair circuit indicated by code output.
YES
> Check instrument cluster.

CHECK INSTRUMENT CLUSTER
Disconnect the cluster connector and turn the ignition switch ON.
Does the ABS warning lamp remains ON?
> Replace the instrument cluster.
> Check for open the wire.

CHECK FOR OPEN IN THE WIRE
Check for continuity in the wire between cluster and ABS control module.
Is there continuity?
> Replace the ABS control module and recheck.
> Repair an open in the wire between cluster and ABS control module.