Combination Switch: Service and Repair

REPLACEMENT

1. Disconnect the negative (-) battery terminal.
2. Remove the steering column upper and lower shrouds (A) after removing 3 screws.




3. Remove the light switch (A) by pushing the lock pin (B) after disconnecting the connector.




4. Remove the wiper switch (A) by pushing the lock pin (B) after disconnecting the connector.




5. Installation is the reverse of removal.

INSPECTION

LIGHTING SWITCH INSPECTION
With the multi function switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.





LIGHTING SWITCH (AUTO LIGHT)





LIGHTING SWITCH





DIMMER AND PASSING SWITCH





TURN SIGNAL SWITCH





FRONT FOG LAMP SWITCH





WIPER AND WASHER SWITCH INSPECTION
With the multi function switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.





WIPER SWITCH





WASHER SWITCH