Monitor DTC Status

Monitor DTC Status

1. Connect scantool to Data Link Connector (DLC).
2. IG "ON".
3. Select "Diagnostic Trouble Codes (DTCs)" mode, and then Press F4 (DTAL) to check DTC's information from the DTCs menu
4. Read "DTC Status" parameter.




5. Is parameter displayed "Present fault" ?
YES
1) Go to "Actuation Test" procedure.
NO
1) Fault is intermittent, go to "Verification of vehicle Repair" procedure.

Actuation Test

1. Connect scantool on the DLC (Data Link Connector)
2. Perform Actuation Test for Canister Vent Solenoid Valve with scantool
3. Check that clicking sound can be heard by actuation test.




4. Is the CCV normal ?
YES
1) Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.
NO
1) Go to "W/Harness Inspection" procedure.