General Information

Component Location





General Description

The CVVT (Continuously Variable Valve Timing) system is installed to the chain sprocket of the intake camshaft. This system controls the intake camshaft to provide the optimal valve timing for every driving condition. The PCM controls the Oil Control Valve (OCV), based on the signals output from mass air flow, throttle position and engine coolant temperature. The CVVT controller regulates the intake camshaft angle using oil pressure through the OCV. As result, the relative position between the camshaft and the crankshaft becomes optimal, and the engine torque improves, fuel economy improves, exhaust emissions decrease under overall driving conditions.

DTC Description

Small particles in the engine oil may cause the oil control valve to bind or otherwise get stuck at certain spool positions. A test is used in this diagnostic to detect a stuck valve spool. A cleaning function is then used to try and free the spool. If unsuccessful, the diagnostic test is failed.
Figure 1. illustrates the principle of the valve stuck diagnostic test. As in the phases error diagnostic illustration, there are two cases shown in the figure. The case on the left shows a case where the duty cycle is above a calibration threshold, yet the phases position is near the minimum position. Under normal operation, such a duty cycle command would move the phases toward its maximum position.The case on the right shows the opposite situation. The duty cycle command is below a threshold, yet the phases position is near its maximum.




PCM monitors OCV stuck while cam offset is available and Valve cleaning is not in progress.If the PCM detects that CAM position angle is over 20 CAD (Crank Angle Degree) than expected cam position that PCM controls the OCV while cam position is in designated crank angle degree, PCM determines that a fault exists and a DTC is stored.

DTC Detecting Condition





Specification





Schematic Diagram





Signal Waveform