Installation

Front Driveshaft

INSTALLATION

1. Apply gear oil on the drive shaft splines (A) and the contacting surface of differential case oil seal (B).
2. Before installing the drive shaft (C), set the opening side of the clip (D) facing downward.





3. After installation, check that the drive shaft cannot be removed by hand.
4. Install the drive shaft into the knuckle.

CAUTION: Be careful not to damage the boot.

5. Install the knuckle in the strut assembly with the tightening torque, 130 - 150 Nm (1300 - 1500 kg-cm, 94 - 108 lb-ft).
6. Install the wheel speed sensor in the knuckle with the tightening torque 8 - 10 Nm (80 - 100 kg-cm, 5.8 - 7.2 lb-ft).
7. Install the tie rod end ball joint in the knuckle with the tightening torque 16 - 34 Nm (160 - 340 kg-cm, 12 - 25 lb-ft)
8. After installing the washer (B) with convex surface outward, install the lock nut (A) and the split pin (C).





9. Install the wheel and tire.