Installation

Clutch Master Cylinder

INSTALLATION

1. Connect the clutch tube (A) (release cylinder side).





2. Temporarily tighten the flare nut by hand, then tighten it to the specified torque, being careful that the clutch hose does not become twisted.





3. Install the clutch tube and clips (A).





4. Install the master cylinder (A).





5. Apply the specified grease to the clevis pin and washer.

Wheel bearing grease: SAE J310, NLGI NO. 2





6. Install the push rod to the clutch pedal.
7. Pour the clutch fluid into the clutch master cylinder.
8. Bleed the clutch system.