Combination Switch: Service and Repair

MULTI FUNCTION SWITCH REPLACEMENT
1. Disconnect the negative (-) battery terminal.




2. Remove the steering column upper and lower shrouds (A) after removing 3 screws.




3. Remove the light switch by pushing the lock pin (B) after disconnecting the connector (A).




4. Remove the wiper switch by pushing the lock pin (B) after disconnecting the connector (A).
5. Installation is the reverse of removal.

LIGHTING SWITCH INSPECTION










With the multi function switch in each position, make sure that continuity exists between the terminals given. If continuity is not as specified, replace the multi-function switch.




TURN SIGNAL SWITCH

WIPER AND WASHER SWITCH INSPECTION










With the multi function switch in each position, make sure that continuity exists between the terminals given. If continuity is not as specified, replace the multi-function switch.

Rear Wiper And Washer Switch (5 Doors):

REAR WIPER & WASHER SWITCH (5 DOORS)