Scan Tool Testing and Procedures

SELF DIAGNOSTIC FUNCTION

DIAGNOSTIC TROUBLE CODES
Inspection procedure





1. Connect SST (OK2CA 089 HSP) to data link connector.
2. Turn ignition switch to ON.
3. Check diagnostic trouble code(s), referring to Hi-scan pro operating manual.
4. If a diagnostic trouble code(s) is displayed, check for cause by using number on diagnostic trouble code table. Repair as necessary.
5. After repairs, perform After-Repair procedure to verify that there are no remaining diagnostic trouble codes.

After-repair procedure
1. Cancel diagnostic trouble code memory by using SST (OK2CA 089 HSP).
2. Remove SST (OK2CA 089 HSP) from data link connector.
3. Drive vehicle at 31 mph (50 km/h), and depress accelerator pedal fully to activate kickdown. Stop vehicle gradually.
4. Connect SST (OK2CA 089 HSP) to data link connector.
5. Turn ignition switch to ON.
6. Verify that no diagnostic trouble codes are displayed.





7. Remove SST (OK2CA 089 HSP) from data link connector.