Manufacture's Scan Tool

AIRBAG SYSTEM

1. Turn ignition switch to ON.
2. The Airbag indicator should illuminate. It it does not, see Airbag Indicator Service.
3. The Airbag Indicator should go out within 4 - 6 seconds. If it stays out, system is OK.
4. If Airbag Indicator remains illuminated, there is a problem in Airbag-Supplemental Restraint System(SRS).
5. Turn ignition switch to LOCK.




6. Locate Data Link Connector (DLC) in engine compartment and install Hi-Scan Pro Tool.
7. Turn ignition switch to ON and record any Diagnostic Trouble Codes displayed by Hi-Scan Pro Tool.
8. Refer to Airbag Diagnostic Troubles Codes Chart, for fault description and actions.

WARNING: Servicing airbag system improperly may cause it to deploy, which CAN cause serious injury or death. Must read and follow all service warnings, before servicing.

CAUTION: Never service wiring or electrical components when airbag is connected.