Rear Combination Light Assembly
Removal1. Disconnect negative battery cable.
2. Remove two fasteners from trunk end trim.
3. Remove trunk end trim.
4. Remove three screws from trunk side trim.
5. While pulling trunk side trim, remove one nut from rear combination light assembly.
6. Disconnect electrical connector.
7. Remove two screws from rear combination light assembly.
8. Remove rear combination light assembly.
Installation
1. Position light assembly on vehicle with studs through mounting holes on vehicle.
2. Install two screws and one nut on rear combination light.
3. Connect electrical connector.
4. Install trunk side trim.
5. Install rear end trim.
6. Connect negative battery cable.
7. Check if function of the rear combination light.