Hydraulic Control Assembly - Antilock Brakes: Service and Repair

COMPONENT

REMOVAL
1. Disconnect the negative battery cable from the battery.
2. Pull up the locker to remove the unit connector.
3. Disconnect the brake lines using a flare nut wrench. Be prepared to catch escaping brake fluid. Temporarily seal open brake lines with plastic caps or equivalent.
4. Remove hydraulic control unit bracket bolts and nut on the vehicle remove unit bracket.
5. Temporarily seal open brake line ports with plastic plugs or equivalent.
6. Store the hydraulic control unit in a protective container while it is being serviced.

REPLACEMENT
1. Install Hydraulic Control Unit into position and tighten the bolts and nut.
2. Reconnect brake lines
3. To hydraulic control unit and connect Hydraulic Control Unit connector. Be certain connectors are fully mated.
4. Bleed the brake system.