Battery - Reset Procedure After Loss of Battery Power
SOURCE: KIA Technician Times Volume 7 Issue 1, 2004TITLE: Component Default Settings Reset Procedure After Loss of Battery Power
APPLIES TO: Amanti
SERVICE TIP:
The increased number of components on Amanti that use a memory feature may require extra attention before, during and after service activities. Before interrupting battery power, use a memory saver tool or write down the pre-sets for climate control and audio. Re-enter this information before delivering the vehicle to the customer.
For items that require the customer's presence in the car; such as, seat and mirror memory pre-sets, explain the reason for the resets and if necessary, provide reset assistance to the customer.
The following components must be reset if battery has been disconnected, discharged, or after memory fuse is removed.
^ Power Windows
^ Sunroof
^ Radio
^ Clock
^ Climate Control System
^ Driver Seat Memory (if equipped)
^ Mirrors Position Memory (if equipped)
RESET PROCEDURES: (Information printed in Owner's Manual)
PowerWindows
Turn ignition to ON position.
Open and close each window and continue pulling up on each window switch for at least 0.5 seconds after the window is completely closed.
Sunroof
Turn ignition to ON position.
Depending on the position of the sunroof:
^ If the sunroof has been closed or been tilted: Press the TILT UP button and hold for 1 second.
^ If the sunroof was open: Press and hold the CLOSE button for more than 5 seconds until the sunroof has completely closed. Then press the TILT UP button for 1 second and release.
Press and hold TILT UP button again until maximum TILT UP position has been obtained.
Radio
Press the pre-set button you want to use to store the station.
Select the desired radio station using the TUNE button.
Press and hold the preset button until a "beep" is heard.
Digital Clock
Press the MODE button.
Select the mode to be reset; hour, minute, month and date.
Reset the data using the Up/Down arrows buttons while the selected mode blinks.
Note: If the Up/Down arrow buttons are pressed for more than 3 seconds, the display will begin to change rapidly. If the Up/Down arrow buttons are pressed then released, the display will change in single increments.
Press the SET button when the data is correct.
Analog Clock
Press the + button to roll the time forward.
Press the button to roll the time backwards.
Climate Control
Press the AUTO button.
Press the TEMP button to the desired temperature.
Trip Computers (if equipped):
No action required: Lost data cannot be re-entered. "Drive time" and "driving distance" will revert back to zero.