Pre-Troubleshooting & Troubleshooting Procedures

CRUISE CONTROL SYSTEM

PRE-TROUBLESHOOTING

Before starting troubleshooting, inspect, and if there is an abnormality, carry out a repair.

1. Check if the installation and connection route of the cable is normal.
2. Check if there is no excessive play or tension in each cable.

TROUBLESHOOTING PROCEDURES

First, select the applicable malfunction symptom from the "TROUBLE SYMPTOM CHARTS".

Determine the condition of all function circuits.

1. Make the following preliminary inspections.
- Check that the installation of the accelerator cable is correct, and that the cables and links are securely connected.
- Check that the accelerator pedal moves smoothly.
- Adjust the cable so there is not excessive tension or excessive play on the accelerator cable.
- Check that the CCM, cruise main and control switch, and the connector of each cancel switch are connected securely.

2. Check in the sequence indicated in the "TROUBLE SYMPTOM CHARTS".
3. If these checks indicate a normal condition, replace the cruise control module.