Rear Door Panel: Service and Repair

Notice: There is no stand alone Rear Door Panel article authored by the manufacturer. This information was extracted from the Rear Door Removal article.

Rear Door Panel Removal and Installation





1. Remove door delta inner cover from door frame.




2. Remove door inner handle cover.
1. Remove cover and screw.
2. Remove door inner handle cover from door trim.

3. Remove door trim.




1. Remove arm rest from door trim.




2. Remove door trim screws(4).




3. Disconnect electrical connector.




4. Remove door trim from door frame.

4. Loosen the door trim mounting screws. Release the clips that hold the door trim, then remove the door trim by pulling it upward. Disconnect the power window switch connector, power mirror connector, and door courtesy lamp connector (if applicable).

5. Installation is the reverse of removal.