Radiator Cooling Fan Motor: Service and Repair

Removal





1. Disconnect negative battery cable.





2. Drain engine coolant.





3. Remove fresh air duct.
4. Disconnect cooling fan motor connector.





5. Remove upper radiator hose.
6. Remove upper two radiator cowling bolts.





7. Remove lower two radiator cowling bolts.
8. Lift radiator cowling from engine compartment.
9. Remove clip and fan.
10. Remove three fan motor bolts and nuts.

Inspection





1. Check current as shown with an ammeter.
Current (A): 8 - 13 A

Replacement
1. Install fan motor and tighten three fan motor bolts and nuts.
2. Install fan and clip.
3. Install radiator cowling to radiator.
4. Install and tighten two upper radiator cowling bolts.
Tightening torque: 69 - 95 inch lbs. (7.8 - 11 Nm)





5. Install and tighten lower two radiator cowling bolts.
Tightening torque: 69 - 95 inch lbs. (7.8 - 11 Nm)





6. Install upper radiator hose.
7. Connect cooling fan motor connector.





8. Install fresh air duct and tighten bolt and nut.





9. Fill engine with coolant.





10. Connect negative battery cable.
11. Start engine and check for leaks.