Input/Turbine Speed Sensor

Input/Turbine speed sensor
Resistance inspection
1. Disconnect negative battery cable.
2. Pull data link connector upward from MAF sensor.
3. Disconnect air temperature sensor connector and MAF sensor connector.
4. Remove air cleaner assembly.
5. Disconnect input/turbine speed sensor connector.
6. Measure resistance between terminals 1 and 2.
Resistance: 300 - 400 Ohms
7. If not as specified, replace input/turbine speed sensor.
Tightening torque: 69.6 - 94.8 inch lbs. (8 - 11 Nm, 80 - 110 kg.cm)
8. Install air cleaner assembly.
9. Connect air temperature sensor connector and MAF sensor connector.
10. Install data link connector to MAF sensor.
11. Connect negative battery cable.