Air Bag - After Deployment Inspection/Replacement Info

SOURCE: Kia Technician Times

TITLE: After Airbag Deployment Inspection/Replacement

APPLIES TO: All models

SERVICE TIP:

After a collision in which the airbags deploy, there are certain parts that require replacement and some that only require inspection to ensure their serviceability. Refer to the chart for specific inspection/replacement information.
- Always wear safety glasses when handling airbag modules.
- Always wear rubber gloves when handling deployed or damaged airbag modules.
- Airbag surfaces may be contaminated with small amounts of Sodium Hydroxide (NaOH). Prevent contact of the airbag module with liquids, combustibles, and flammable materials. Immediately wash contaminated hands and skin areas with mild soap and water. Flush eyes with water if exposed to by-products. Failure to follow these instructions could result in chemical burns and personal injury.






NOTES:
1. The plastic knee airbag mounting screws must be replaced.
2. Inspect the headliner, pillar trim and related interior components after side curtain deployment and replace as required.
3. Inspect the side airbag sensors and airbag harness at the sill and B-Pillar area after side or curtain airbag deployment.
4. Inspect inside the front fenders and bumper for damage to the front sensors and airbag harness after frontal collision.
5. The Sephia/Spectra/Rio ADU will be in an "After Deployment Mode" and must be cleared. Clear the ADU by performing the scan tool airbag code clear function.
6. Carefully inspect the drivers airbag connector for melting and replace the clockspring if necessary.

NOTICE After replacing/inspecting parts, check for any airbag DTCs (if airbag indicator light stays on). Diagnose, inspect and repair.