Generator Belt
Replacement1. Remove A/C and P/S drive belt, if equipped.
NOTE: Refer to section 11.
2. Loosen generator mounting bolt and adjusting bolt.
3. Remove generator belt.
4. Install new generator belt and adjust to specification.
5. Tighten all bolts to specified torque.
Tightening torque Mounting bolt: 27 - 38 lb.ft (37 - 52 N.m, 3.8 - 5.3 kg.m)
Adjusting bolt: 14 - 18 lb.ft (19 - 26 N.m, 1.9 - 2.6 kg.m)
6. Install A/C and P/S drive belt, if equipped, and adjust to specification.
NOTE: Refer to section 11.