Input/Turbine Speed Sensor
INPUT/TURBINE SPEED SENSORResistance inspection
1. Disconnect negative battery cable.
2. Pull data link connector upward from MAF sensor.
3. Remove air cleaner assembly.
4. Disconnect input/turbine speed sensor connector.
5. Measure resistance between terminals 1 and 2.
Resistance: 300 - 400 ohms (@ 68°F/20°C)
6. If not as specified, replace input turbine speed sensor.
Tightening torque: 69.6 - 94.8 inch lbs. (8 - 11 Nm, 80 - 110 kg-cm)
7. Install air cleaner assembly.
8. Install data link connector to MAP sensor.
9. Connect negative battery cable.