Control Valve Body (Removal)

CONTROL VALVE BODY (REMOVAL)

NOTE: Clean transaxle exterior thoroughly with a steam cleaner or cleaning solvents before removal.





1. Support engine with SST (OK201 170 AA0).
2. Raise vehicle and support it with safety stands.
3. Drain ATF into a suitable container.
4. Remove both gravel shield from under engine.





5. Remove nuts from No. 2 engine mount-to-mounting member.
6. Remove engine mounting member-to-chassis bolts and nuts then remove engine mounting member.
7. Remove oil pan (19 bolts) and gasket.





8. Disconnect all electrical connectors, remove eight bolts, and remove control valve body.