FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Front Lap / Shoulder Belt Assembly

Safety Belts:






REMOVAL




1. Remove one mounting bolt from lower anchor.
2. Retract belt slowly as far as it will go.
3. Unsnap captive shoulder belt anchor bolt cover from bottom and lift up.




4. Remove one upper anchor bolt.
5. Remove retractor assembly.

CAUTION:
1. A pretensioner functions one time only. Be sure to replace the pretensioner safety belt after is is deployed.
2. Do not attempt to disassemble or repair the seat belt pretensioner. If it malfunctions, replace it with a new pretensioner safety belt.
3. Be cautions in handling a pretensioner safety belt, and do not expose it to water or oil. If crushed, damaged, or deformed, replace it with a new one.
4. Connect the battery only after the installation of the pretensioner safety belt has been correctly completed.
5. Renivak if oretebsuiber retractor :
a. Turn ignition switch "OFF".
b. Disconnect negative battery cable.
c. Wait for bout 1 minute.
d. Disconnect has generator connector.
e. Remove retractor screw.

1. Remove B-pillar lower trim.
2. Disconnect electrical connector from retractor assembly.




3. Remove one sheet metal screw to remove retractor assembly.

6. Remove shoulder adjuster.
1. Remove two sheet metal screws to remove belt guide.
2. Unfasten B-pillar upper trim.




3. Remove two mounting bolts from shoulder adjuster.