Removal and Installation
TAIL, PARKING AND LICENSE LAMPSREMOVAL (OUTSIDE)
1. Disconnect negative battery cable.
2. Remove two bolts from service hole cover.
3. Remove four nuts attaching rear combination light assembly to vehicle.
4. Disconnect electrical connector.
5. Remove light assembly.
REMOVAL (INSIDE)
1. Disconnect negative battery cable.
2. Remove three screws and thirteen fasteners from trunk lid trim.
3. Remove back panel molding assembly.
1. Disconnect electrical connector.
2. Remove one screw from outside of trunk lid.
3. Remove thirteen nuts from trunk lid.
4. Remove four screws from light assembly.
INSTALLATION (OUTSIDE)
1. Position light assembly on vehicle with studs through mounting holes on vehicle.
2. Connect electrical connector.
3. Install four nuts on rear combination light.
4. Install two bolts on service hole cover.
5. Connect negative battery cable.
INSTALLATION (INSIDE)
1. Position light assembly on back panel molding assembly.
2. Install four screws on light assembly.
3. Install back panel molding assembly.
1. Install thirteen nuts on trunk lid.
2. Install one screw on outside of trunk lid.
3. Connect electrical connector.
4. Install three screws and thirteen fasteners on trunk lid trim.
5. Connect negative battery cable.