Rear Seat Belts Inspection

1. Inspect three buckle assembly mountings to ensure that they are secure. (This is done from rear of vehicle.)
2. Inspect remaining belt's mounting to ensure that it is secure. (This is done from rear of vehicle.)
3. Pull safety belts to rear between seatback and cushion.
4. Remove seat cushion.
5. Inspect outboard lap belt mountings to ensure that they are secure.
6. Disconnect fasteners of C-pillar trim from body and pull C-pillar trim down completely.
7. Fold rear seatback forward for front side of seat cushion.
8. Remove package tray.
9. Inspect retractor assembly mountings to ensure that they are secure.

WARNING: If a safety belt is not functioning and cannot be immediately repaired, warn the customer not to use that seating position. If the customer must use that seating position, encourage the customer to use a substitute vehicle until the proper repairs can be made. If the customer refuses, refer the matter to the Service Manager.