Torque Converter: Testing and Inspection
Torque converterThe torque converter is welded together and cannot be disassembled.
Inspection
1. Check outer surface of converter for damage or cracks and replace it if necessary.
2. Check whether there is any rust on pilot hub of converter or on boss. If there is any, remove it completely
3. Measure bushing of converter boss Replace converter assembly if bushing is worn
Bushing inner diameter
Standard: 2.088 inch (53.030 mm)
Maximum: 2.090 inch (53.075 mm)
Washing inside converter
1. Drain any ATF remaining in converter.
2. Pour in ATF, 0.5 US quarts (0.5 liter, 0.44 Imp quarts).
3. Shake converter to clean inside. Pour out ATF.
4. Pour in ATF.
5. Shake converter to clean inside. Pour out ATF.
Notice: Replace torque converter if it contains any metallic particles.