Printed Circuit

4 DOOR

Removal
1. Remove bulb holders from rear of instrument cluster.
2. Remove mounting screws from printed circuit area.




3. Lift printed circuit off of mounting tips.

Installation
1. Place printed circuit on rear of instrument cluster over mounting tips. Press each tip through its mating hole securely.
2. Install mounting screws through screw holes in printed circuit area of back of instrument cluster.
3. Install bulb holders through holes in printed circuit into sockets in instrument cluster.

5 DOOR

Removal
1. Remove bulb holders from rear of instrument cluster.
2. Remove 13 mounting screws from printed circuit area.




3. Lift printed circuit off of mounting tips.

Installation
1. Place printed circuit on rear of instrument cluster over mounting tips. Press each tip through its mating hole securely.
2. Install 13 mounting screws through screw holes in printed circuit area of back of instrument cluster.
3. Install 19 bulb holders through holes in printed circuit into sockets in instrument cluster.