Rear Door Window Regulator: Service and Repair

Notice: There is no stand alone Rear Door Window Regulator article authored by the manufacturer. This information was extracted from the Rear Door Removal article.

Rear Door Window Regulator Removal and Installation

1. Remove one screw on outside belt weatherstrip.
2. Remove outside belt weatherstrip.
3. Remove door trim. Refer to "Trim".
4. Remove one screw on pull handle bracket.




5. Remove pull handle bracket.




6. Remove inside door handle assembly.
a. Remove one screw from inside door handle.
b. Disconnect two control rods.
c. Remove inside door handle assembly.

7. Peel off plastic door screen carefully by pulling it away gradually from door frame.
8. Remove glass run channel.
9. Remove one screw and one bolt from center channel.
10. Remove center channel.
11. Remove quarter glass

12. Remove window glass




a. Remove two glass retaining bolts on regulator assembly




b. Remove door glass carefully. Hold glass from both its inner and outer surfaces. While tilting it toward hinge side of door, pull it out from outside door frame.

13. Remove two nuts on outside door handle from access hole.




14. Remove outside door handle.




15. Remove three screws on door lock assembly.
16. Remove door lock assembly from access hole.




17. Remove six nuts on window regulator assembly.
18. Remove window regulator assembly from access hole.

19. Installation is the reverse of removal.