Brake Pedal Assy: Service and Repair

Removal
1. Disconnect the negative battery cable.
2. Remove the split pin from the brake pedal clevis pin and remove the pin.
3. Remove the pivot bolt attaching nut, lockwasher, and spring washer.
4. Remove the spacer from the pivot bolt.
5. Slide the pivot bolt to the right and remove.
6. Remove the brake pedal, brake pedal return spring, and spacers.
7. If necessary, remove the brake pedal bushings, foot pad, and stop bumper.

Installation
1. If necessary, install the brake pedal stop bumper, foot pad, and bushings.
2. Position the brake pedal spacer and slide the pivot bolt through to hold it in position.
3. Position the return spring on the brake pedal.
4. Position the clutch pedal, if equipped, and slide the pivot bolt through to hold it in position.
5. Install the clutch pedal spacer, if equipped.
6. Install the pivot bolt attaching washers and nut.
7. Install the brake pedal clevis pin and split pin.
8. Connect the negative battery cable.