With Manufacturer's Scan Tool

Self-diagnosis procedures





1. With the ignition switch OFF, connect the diagnostic scan tool (Hi/Scan pro) to the data link connector in the engine compartment.
2. Turn the ignition switch ON, then check diagnostic trouble code(s).
3. If a diagnostic trouble code(s) is displayed, check for cause by using number on diagnostic trouble code. Repair as necessary.
4. After repair, perform after-repair procedure to verify that there are no remaining diagnostic trouble codes.

Notice: If Hi/Scan pro is not available, check the blinking code by the ABS warning lamp.





a Ground the pin "i" end "r" of data link connector in the engine compartment with the ignition switch OFF.
b Turn ignition switch ON.
c DTC's will be displayed beginning will the lowest DTC number first.





d After all stored DTC's have been displayed, the process will repeat and display the lowest DTC number first.

A: 0.1 Seconds





Notice: The ABS warning lamp illuminates for 0.1 second after the ignition switch is turned ON. This does not indicate an error code.

B: 4 Seconds
C: 0.5 Seconds
D: 1.5 Seconds
E: 2.5 Seconds or 4 Seconds

Notice:
^ The OFF state between DTC display cycles is 4 seconds.
^ When several DTC's are displayed, the OFF state between codes is 2.5 seconds.





F: All Clear Code - 0.25 Seconds

^ Notice: If the system is operating nominally (no malfunction) the warning lamp will blink once every 0.25 second. This is the "All Clear" code.