Shifter A/T: Service and Repair

AUTOMATIC TRANSAXLE SHIFT CONTROL





REMOVAL





1. Remove the two front console screws.
2. Remove the two rear console screws after moving front seats forward.
3. Remove two seat heater switches on the center panel.
4. Remove lever panel.





5. Remove the center panel, pulling out the center with hand after loosening two screw panel trim.
6. Remove the 12V power outlet connector pin from the center panel.





7. Remove the console after loosening four screws from the console bracket.





8. Remove the shift lock cable and the key lock cable.
9. Remove the control cable clip and pin from the shift levers.





10. Remove the shift lever mounting bolts and connector.
11. Remove the shift lever assembly.





12. Remove the clip, flange nut from the transaxle sides.
13. Remove the transaxle control cable assembly.
14. Remove the shift lock cable and the key lock cable.

INSTALLATION





1. Apply a coating of the specified grease to the interior of the adjust bushing.
Specified grease........Chassis grease SAE J310, NLGI No.O
2. Move the shift lever and the transaxle range switch to the "N" position, and install the transaxle control cable.





3. When connecting the control cable to the transaxle mounting bracket, install the clip until it contacts the control cable, in the position shown in the picture.
4. Install the shift lever assembly and connector.
5. When connecting the control cable to the shift lever mounting bracket, install the clip until it contacts the control cable.
6. Install the control cable, the key lock cable and the shift cable mounting bolt.
7. Position the console and tighten eight screws.





8. Install the center panel after connecting 12V power outlet pin, then tighten two screws.





9. Install lever panel.
10. Install two seat heater switches to the center panel.