Rear Door Window Regulator: Service and Repair

Notice: There is no stand alone Rear Door Window Regulator article authored by the manufacturer. This information was extracted from the Rear Door Removal article.

Rear Door Window Regulator Removal and Installation

1. Remove inner glass weatherstrip.

2. Remove door trim.




3. Remove one screw on pull handle bracket.

4. Remove inside door handle assembly.
a. Remove three screws from inside door handle.
b. Disconnect two control rods.




c. Remove inside door handle assembly.

5. Peel off plastic door screen carefully by pulling it away gradually from door frame.
6. Remove window glass:
a. Reconnect window operating switch.
b. Connect negative battery cable.
c. Turn on ignition and position window glass about halfway.
d. Turn off ignition.
e. Remove two glass retaining bolts on regulator assembly.




f. Remove door glass carefully. Hold glass from both its inner and outer surfaces. While tilting it toward hinge side of door, pull it out from outside door frame.
g. Disconnect negative battery cable.

7. Remove harness connector.

8. Remove two nuts on outside door handle from access hole.




9. Remove outside door handle.




10. Remove three screws on door lock assembly.

11. Remove door lock assembly from access hole.

12. Disconnect window regulator motor connector.




13. Remove six nuts on window regulator assembly.

14. Remove window regulator assembly from access hole.

15. Installation is the reverse of removal.