Oil Pump Replacement

REMOVAL





1. Disconnect negative battery cable.





2. Drain engine oil.
3. Remove timing belt.
4. Remove oil pan and oil strainer.
5. Remove generator.
6. Remove A/C compressor and A/C compressor bracket if equipped.
7. Remove crankshaft pulley lock bolt.
8. Remove timing belt pulley.





9. Remove oil pump mounting bolt.
10. Remove oil pump.

INSTALLATION

1. Apply a continuous bead of silicone sealant to oil pump sealing surface.

CAUTION: The oil pump must be installed no longer than 5 minutes after silicone sealant is applied.





2. Apply grease to a new O-ring and install it in oil pump.
3. Install oil pump.

Tightening torque: 14 - 19 ft. lbs. (19 - 26 Nm, 1.9 - 2.6 kg-m)





4. Install timing belt pulley and crankshaft pulley lock bolt.

Tightening torque: 115.7 - 122.9 ft. lbs. (156.8 - 166.6 Nm, 16 - 17 kg-m)

5. Install A/C compressor bracket and A/C compressor.
6. Install generator.
7. Install oil strainer and oil pan.
8. Install timing belt.
9. Fill with specified amount and type of engine oil.





1O. Connect negative battery cable.
11. Start engine and check for leaks.
12. Check oil level and add oil if necessary.