Fluid - M/T: Service and Repair
Oil change1. Raise vehicle and support it with safety stands.
Notice: Keep vehicle level when checking oil level.
2. Remove drain plug at bottom of transaxle case and drain fluid into suitable container.
3. Install new washer on drain plug and reinstall plug in case.
Tightening torque: 29 - 43 ft. lbs. (40 - 58 Nm, 4.0 - 6.0 kg.m)
4. Remove oil level plug from transaxle case.
5. Add specified amount and type of oil into oil level plug hole until level reaches bottom of hole.
Specified oil:
Grade: API Service GL-4
Viscosity: SAE75W-90(TGO-6)
Capacity: 2.9 US quarts (2.7 liters, 2.4 Imp quarts)
6. Install new washer on plug and reinstall plug in case.
Tightening torque: 29 - 43 ft. lbs. (40 - 58 Nm, 4.0 - 6.0 kg.m)
7. Warm up vehicle until transaxle oil reaches its normal temperature, then check for leakage of transaxle oil.
8. Lower vehicle.