Fluid - A/T: Testing and Inspection

Caution Place vehicle on a flat, level surface.

Inspection
1. Apply parking brake and position wheel chocks securely to prevent vehicle from rolling.
2. Warm-up engine until ATF reaches 140 - 158°F (60 - 70°C).
3. While engine is idling, shift selector lever from P to 1 and back to P.
4. Let engine idle.
5. Shift selector lever to P.

Notice: Use COOL 68°F (20°C) range only as a rough reference.






Dipstick Location






6. Ensure that the ATF level is in HOT 149°F (65°C) range. Add ATF to specification, if necessary.
ATF type SK ATF SP-III

Fluid condition

Notice: Carefully check condition of ATF and determine whether or not automatic transaxle should be disassembled.
If ATF is muddy and varnished, it could indicate burned drive plates or brake band.

1. Check ATF for discoloration.
2. Check ATF for any unusual smell.