Receiver Dryer: Service and Repair

Removal
1. Discharge refrigeration system. (Refer to operating instructions of your refrigerant recovery/recycling/charging station for proper procedures.)
2. Remove receiver/drier as shown.

NOTE: Immediately plug open fillings to keep moisture out of system.

Installation
1. Install receiver/drier in reverse order of removal.

NOTE:
a. Apply clean compressor oil to O-ring before connecting fittings.
b. Do not apply compressor oil to fitting nuts.




c. When installing a new receiver/drier, add compressor oil through high-pressure pipe port of compressor. Compressor oil 0.61 cu in (10 cc)

Tightening torque
Receiver/drier inlet: 43 - 61 lb-in (4.9 - 6.9 N.m, 50 - 70 kg-cm)

Receiver/drier outlet: 43 - 61 lb-in (4.9 - 6.9 N.m, 50 - 70 kg-cm)